PR-106a
GM Distribution Block
Applications:
1967-69 Chevrolet Impala (No Mounting Bracket)
1967-69 Oldsmobile 88 / 98 (No Mounting Bracket)
1967-69 Pontiac Bonneville / Catalina / GP (No Mounting Bracket)
1967-69 Buick Electra / LeSabre (No Mounting Bracket)
Brass
$89.00
Valve Notes:
Now available is the 1967-69 Distribution Block. This block was
used on all cars either disc or drum. This block is located below the master
cylinder. This is not a proportioning valve; it does not hold
off pressure except if there is a loss of pressure in either the front or rear
brakes. It will then contact the brake warning light in the dash. In 1968-69 and
70-72, this block is used on all drum cars, and in 1967-70 with the round hold-off
valve at the master on disc brake cars. In 1971, the disc brake cars use a
different valve and the drum brake applications continue to use this valve. This
block gives equal pressure to the front and rear brakes and is also great for 4
wheel disc applications. 1968-69 and 70-72 are very similar valves except the
fitting sizes change for the different year brake lines.
This item is an exact reproduction featuring a brass body and working insides. You will also find with current manufacturing
procedures, the reproduction has no tool stamping marks and the edges of the
part are much cleaner than the original.
GM Notes:
1967-70 cars all came standard with a dual master cylinder and
drum brakes. 1967 was also the first year for optional disc brakes. If the car had
either drum or disc brakes, there was a distribution block with a built-in brake warning
switch down on the frame below the master cylinder. From 1967-69, if the
car had factory disc brakes it used the drum dist. block in conjunction with a
disc brake hold-off valve, which made the disc cars a 2 part valve system.
In 1970, GM added a third valve in the rear line for brake correction, so the 1970
system had three valves. For cars converting to disc
brakes, aftermarket replacement 1-piece valves are also available. Conversion
valves will not plumb into existing factory lines.
Prop. Valve Brackets are available for all cars with disc
conversions, this bracket is $18.00.
