PR-101

Proportioning Valve - Street Rod

Street Rod - Brass 5 Port Valve  Front Disc - Rear Disc 

Brass
$99.00

Valve Notes:
The 5 port valve works great on factory cars that have been converted to disc brakes. This valve is preset for disc brakes in the front and rear. The 5 ports are; 2 ports on top for the lines from the master cylinder to the valve, 1 right front port, 1 left front port and 1 port for the front to rear brake line. This valves serves as a replacement on all GM cars from 1971-86. This valve is also used on the 1964-72 GM disc brake conversions. There is no adjustment on the valve. It is set to be 50% front brake, 50% rear brake pressure.

GM Notes:

1964-66 cars all had a single master cylinder with drum brakes. There was no proportional valve and no disc brake option available in these years. The tee block that mounted to the frame served as the distribution block. When converting to disc brakes, the system will need a prop. valve. This aftermarket valve mounts on the frame similar to the 1967 cars or on a bracket below the master.

1967-70 cars all had a dual master cylinder and were available in drum, and 1967 was the first year for disc brakes. If the car had drum brakes, there was a distribution block with a built-in brake warning switch. If the car had factory disc brakes, it used the drum dist. block in conjunction with a disc brake hold off valve, which made the disc cars a 2 part valve. For disc brake conversions, replacement aftermarket 1 piece valves are available, see listing. This valve will not plumb into existing factory lines. 

Prop. Valve Brackets are available for all cars with disc conversions, this bracket is $18.00.